Close
Subscribe to newsletters
Email:
COPPELL TV REPAIR LLC WILL BE CLOSED FROM DEC 21ST UNTIL MID TO LATE JANUARY 2025.

Orders can be placed at the moment, but repair service initiations are blocked in advance to avoid boards arriving while we are closed. Processing of CORE returns will also be delayed during the period of closure. Shipments to the shop will still be received, but we advise to just hold shipping anything until you see removal or update of this message.

We thank you for your support and wish you happy holidays and good health in 2025!

Vizio E422VA main board 756TXACB5K005 / 715G4365-M01-000-005K / TXACB5K05203 EEPROM / firmware replacement IC


The repair kit contains replacement for the memory IC that contains the Vizio E422VA firmware. Read listing for full details!

In stock

$29.95
:

Coppell TV Repair LLC offers the EEPROM / flash memory IC containing the firmware for Vizio E422VA main board 756TXACB5K005 / 715G4365-M01-000-005K / 756TXACB5K05203.

Please read carefully the below information and specifically the warranty conditions section!

Do not hesitate to ask if you have questions and good luck with your TV repairs!

Kit ID: CTVRK-PB-NO-0093

Kit contents: The EEPROM / flash memory IC U405 found on Vizio main board 756TXACB5K005 / 756TXACB5K05203 used in Vizio E422VA LED TV. Located right next to the large heat sink in the middle of the board.

Difficulty level: Medum to advanced. The memory IC requires soldering by experienced technician with quality soldering tool.

Generic firmware failure symptoms: As with most if not all other cases for failed firmware there is no simple and definite way to test confirm the problem is there, let alone only there. Below are some symptoms we've seen caused by a defective memory IC however you should bear in mind other failures may lead to the same symptoms.

  • A totally dead TV; this is actually model specific. Some older TVs have separate standby processor and most newer models use a single processor for standby and full operation mode. A bad firmware (or bad clock generator, for example, or bad solder joint on the processor) could leave the entire board dead.
  • Some TVs may be blinking a number of time and pausing or just continuously blinking , in either case not responding to any button. Some may respond to the power on only to start the blinking procedure again.

The most common failures we've seen when the E422VA firmware is bad are: 1) Totally dead TV (no front LED) and no response; 2) Front LED lighted up, but not bright and no response to buttons (it should normally get brighter and start blinking for a normal startup); and 3) front LED blinking endlessly.

Repair service offered: Yes. If you consider the job too difficult or like to use the benefits of the warranty our repair services carry (and which our repair kits do not) search at our site for a risk free repair service for Vizio E422VA main board.

WARRANTY CONDITIONS

Coppell TV Repair LLC does not guarantee that this product is all that is needed to resolve the problems with your TV.

Most of the repair kits we offer are based on first hand experience servicing boards at our repair facility. 

Over time they may get expanded with our own experience or information from manufacturer service bulletins, customer feedback etc.

Yet failure can be unique and there can not be guarantee that what has worked one, ten or even hundred times will also work the next one.

Just as important, every repair involves about equal portion of quality of parts and quality of worksmanship and as we have no control over the worksmanship quality unless we are the ones performing it we would be unwise to provide warranty of the products utilized by that worksmanship.

As such, no warranty is offered on this product once the components in it are soldered on a board.

If you would like warranty please see if a REPAIR SERVICE is offered instead of a kit. Unless otherwise noted all our repair services do come with a standard warranty.

PRODUCT DISCLAIMER

Coppell TV Repair LLC is not aware of an easy and reliable way available to end users that will allow them to identify beyond doubt a defective or corrupt memory IC.

We describe failure symptoms that we have seen when the firmware IC was corrupted, but those symptoms do not directly map to defective memory IC and the other way around - an EEPROM can be deffective or corrupt and there may be other symptoms that are not listed here.

It is up to the buyer's technical skills, equipment and willingness to assume the risk for the outcome of their repair service effort when purchasing and using this product!

By placing an order customers agree to assume that risk and hold Coppell TV Repair LLC free of accusations and charges related to the outcome of their repair except in regards to the correct presentation of the product and its delivery.

Coppell TV Repair LLC guarantees that the offered memory is new, tested and functional to the best of company's knowledge.

To anyone who does not have the skill and equipment needed to diagnose the IC in their own board we strongly recommend using a purchase/trade-in or a repair service, which we may (and should) be offering for the main board.

SHIPPING AND HANDING

Products will usually ship on the next business day after purchase is placed and paid. Unexpected delays may occur. If you do not receive a tracking number or message from us within 3 business days after purchasing please contact us.

When shipping method is specified during payment it is our first choice to utilize that method for shipping.
Yet sometimes it is not possible or may result in delays, e.g. a late Friday FedEx shipping of inexpensive and durable product may have a chance of being shipped in Friday than the following Monday; in such cases we reserve the right to substitute FedEx Ground with USPS Priority and, in some very rare cases, USPS First Class service. If shipping costs differ significantly you are in your right to contact and request price adjustment.

When shipping option for the order is "Free shipping" we will usually utilize cheapest available method.
See below for important disclaimer regarding the USPS First Class Mail packages.

    We do not advertise delivery time and do not take responsibility for delays to packages as long as tracking information proves they have been shipped in a timely manner by us.

    Be advised that the following delivery services are NOT insured per USPS policy:

    • Domestic: USPS First Class;
    • International: First-Class Package International™, Priority Mail International® Flat Rate Envelopes and Priority Mail International® Small Flat Rate Boxes; services to some countries may also not be covered, for details read the USPS article on the subject.

    What this means is that if you choose any of the above services as your delivery method you agree to hold us free of claims against loss of value should your package gets damaged or lost in the carrier system as long as the tracking information by the carrier shows the package was accepted by them and processed into their system.